|
|
The Complete Airflow Kit is a total system,
created by Soros, Inc., that will improve the cabin
air flow and passenger comfort in General Aviation
aircraft, specifically Cessna aircraft.
Better airflow means more comfort
For proper climate control in your aircraft's cabin,
air that enters must be allowed to exit the aircraft
in an efficient way. When air can't escape, the
effect is like blowing into a bottle. The Airflow Enhancement Kit improves cabin air flow by
approximately 30 percent. Which means you fly in greater comfort. Also the Heater performs better.
Why you need the Airflow Enhancement Kit
The Airflow Enhancement Kit works with your
Ventubes™ to give you even better ventilation in your aircraft. Historically, the Cessna
cabin had sufficient air leakage to mitigate the air flow problem. As the aircraft have matured,
they have been renovated with better insulation, and tighter seals around the doors and windows.
These renovations have reduced the air leakage and, at the same time, decreased air flow in the
cabin. The Airflow Enhancement Kit by Soros, Inc. will dramatically improve the air flow in your
craft.
Installation
Cabin Exit Vent and Fuselage Exit Vent can be installed under the
owner/operator regulations. Approximate installation time is 2 hours for CEV and 30 minutes
for FEV.
|
|
Product Specifications
Ventube™ is a plastic unit consisting
of an exterior tube and a lockable interior tube
with a cap. Just turn the interior tube cap
clockwise which pulls the cap against an O-ring
seal to close the vent. Airflow control is
accomplished by extending or retracting this
interior tube. A simple twist of the interior
tube controls air direction. The locking cap,
friction rings and coins, tolerance between the
tubes, and the O-ring seal work together to
provide quiet and controlled air flow.
Cabin Exit Vent: 2 aluminum, louvered, round grills
installed behind the seats in the non-structural area near the baggage compartment; i.e., the
rear baggage panel or baggage shelf.
Fuselage Exit Vent: an aluminum, louvered, round grill (mounted in a non-structural
inspection plate) that is installed by replacing an existing non-structural inspection plate
in the rear fuselage area. The grill is equipped with a screen to deter insects and water from
entering.
The Kit includes:
Ventubes™ (pair) - controls air flow into the
cabin
2 Cabin Exit Vents - allows air to exit to fuselage.
1 Fuselage
Exit Vent - allows air to exit the aircraft. Fits most Cessna
120, 140, 150, 152,
170, 172, 175, 177, 180, 182, 185, 190, 195, 205, 206, 207, 210.
Part#: KVENTCombo
Price: $143.75 per kit
Qty:
|
