INSTALLATION INSTRUCTIONS
FOR
CESSNA P210

Drawing No. RCS-300

The sunvisor has been a neglected piece of equipment in most aircraft and especially in the smaller models such as the Cessna single engine line. Rosen Products LLC has worked very diligently to produce the best possible sunvisor systems for these aircraft.

There are four basic visors in the original Cessna line as shown below and primarily determine which Rosen NSA System is to be used. With the exception of the 210 (non-pressurized) and 152's with the factory system, it is a simple matter of unbolting the original visor and bolting on the Rosen unit With the majority of 210's (non-pressurized) the unit will take approximately one to one and a half hours to install. The 152's mentioned above will take Part #RCS-300-1 but since there are no fasteners to pick up, a mechanic will need to install the rivnuts
that are supplied. (Note: Aircraft with air conditioning will require Part #RCS-300-4.)

Please review the following diagrams to insure that you have received the correct part number and then proceed to your particular instructions.

Original Visor Mounting Locations
Correct Rosen Replacement Part Numbers

 

---

Part # RCS-300-4

Tools Required: Phillips screwdriver.

This P210 system replaced the original visor that is mounted with two screws. This installation requires only a Phillips screwdriver and the Allen wrenches supplied with the kit.

Remove both pilot's and copilot's original Cessna visor with a Phillips screwdriver.

Take out the visor assembly marked "pilot's side" and, using two #8 socket head cap screws and black anodized washers, attach the mounting bracket to the original hard points. The slots in the bracket allow for miss mounting of the original visor screws.

Tighten the pilot's side securely using the 5/32" Allen wrench supplied in the kit.

Repeat the same procedure for the copilot's visor assembly.

This installation should take approximately 10 minutes.

NOTE: If at any point in the future you feel there if too much flex in the bracket when the visor is extended to the rear, a rivnut and fastener are included to mount to the spar using the extra 3/16" hole in the black anodized bracket.

---

For further assistance with the installation of Rosen Sunvisors, please contact Rosen: 86364 College View Road, Eugene, Oregon 97405 Telephone 541.747.0034 * 800.284.7677 Fax 541.747.1169 Website www.rosenvisor.com